I am new here(to the forum (not to fab)). Just thought I would post my project for critismn and ideas. 1972 GMC C-10 Longbed. It is currently bagged just not low enough(basically as low as it can get with cutting only the lower control arms). So now the direction changes. To include step notch, drop spindles, watts link, and more. But I do have a few questions. As I have not bagged one with a trailing arm set up. The main question being, should I just scrap it. And do a triangulated 4 link. Like I do with leaf sprung rigs. Or to use stengthened stock suspension adding a hand built watts link. So as you can see making up my mind is the hard part.